Strong Enough To Handle Recoil of M107 .50 BMG Rifle
Badger Ordnance’s USMC SASR 34mm Scope Rings will reliably maintain your scope’s position, even under the punishing recoil of a .50 BMG. These rings are standard-issue on the U.S. military-issue M107 Special Applications Scoped Rifle.
Badger Ordnance USMC SASR 34mm Scope Rings are machined as matched pairs to provide precision alignment for your optic, eliminating the risk of scope damage caused by misaligned rings.
- Includes inserts so scopes with 1" tubes can be mounted using these rings
- 4 cap screws on front ring / 6 cap screws on rear ring
- Ordnance grade steel
- Black oxide finish
- NSN #1005-01-537-8616
Badger Ordnance USMC SASR 34mm Scope Rings provide impressive strength without unnecessary bulk.
Provide Precise Fit To Receiver
Machined from steel bar stock to provide a strong mounting system with a smooth profile. Precision cut dovetails have the correct angle for an exact fit. Torx® clamp screws snug down tightly for maximum holding power.
Big Book Catalog, Issue:71, Page:266
SPECS: Steel, blue, satin finish. Accept 1" scopes. Height from top of base to bottom of ring: Low - 313" (8mm). High - .600" (15.2mm). Sold in pairs. T/C Classic rings require Talley bases.
The Nightforce X-Treme Duty Ultralite 1-Piece MagMount adds a third crossbolt for even greater protection against recoil.
The Nightforce X-Treme Duty Ultralite 1-Piece MagMount adds to the tough and reliable Nightforce Xtreme-Duty Ultralite Unimount and Magmount mounting systems, with titanium/aluminum construction providing the performance of steel at half the weight. The Compact Magmount requires less rail space than the traditional Magmount, and is available to fit 34mm riflescope tubes.
- Machined from heavy-duty aluminum
- Matte-black finish
- Height: 0.84 inches
- Fits standard Picatinny rails
Options available for the Nightforce X-Treme Duty Ultralite 1-Piece MagMount include both zero and 20 MOA of taper.
Promotional Codes are not applicable to Nightforce products.
Smooth Profile, Horizontal Split
The strongest small bore scope rings available. Designed to fit a very wide selection of rifles and fit both 3/8” and 11mm dovetails. This is made possible by using a solid steel asymmetrical reversible clamp that can be flipped 180° and used on wider or narrower dovetails for best fit. Features a 70/30 horizontal construction and are only 1/2” wide. Attachment is made to the dovetail using a single T-15 Torx style fastener and have 2 of the same fasteners for the ring top strap holding the entire package together securely.
Big Book Catalog, Issue:71, Page:269
SPECS: Steel, powder coated, black, matte or gloss finish. Height measured from top of base to inside, bottom of ring. Medium – .406" (10.3mm) nominal high. High - .525" (13.3mm) nominal high.
Give Uniform High-Strength Clamping Power
Steel caps with two screws per side provide extra strong, 4-screw, clamping power. Helps ensure that reticle stays square while tightening top screws. Large clamp nut locks rings to base, provides easy scope installation, removal; and accurate return to zero after re-installation.
Big Book Catalog, Issue:71, Page:274